-
Anatomy of a Probe Station System
The probe station system is divided into a manual probe station and an automatic probe station. Below we mainly analyze the manual probe station:
Probe station use:
The manual probe station is also known as the probe test station. The main purpose is to provide a test platform for the electrical parameter test of semiconductor chips. The instrumen
2018-10-055300
-
How the manual probe station works
Manual probe station use:
The main purpose of the manual probe station is to provide a test platform for the electrical parameter testing of semiconductor chips. The probe station can absorb a variety of chip specifications, and provides multiple adjustable test pins and probe holders, which can be used to complete integrated circuits with measu
2018-06-055080
-
Optical platforms, also known as optical breadboards, optical tabletops, scientific desktops, and experimental platforms, provide a level and stable tabletop. Generally, platforms need vibration isolation and other measures to ensure that they are not disturbed by external factors and allow scientific experiments to proceed normally. At present, there are two main categories: active and passive
2018-04-208312
-
自動平衡型氣浮防震桌的安裝手冊
1、 常規配置
2、 安裝前請注意以下幾點：
（1） 避免陽光直射和較大的溫度變化
（2） 只能使用壓縮空氣或者4Kgf/㎠以上壓力的氮氣
（3） 避免意外撞擊防震桌
3、 安裝和調整
請按照以下順序安裝
（1） 移動和裝載
a、 移動蜂窩平臺和框架至要求安裝的地方
b、 把蜂窩平臺放在框架上（調整蜂窩到框架的中心位置）
（2） 調整框架的水平位置和裝載設備
a、 擰松校平腳上的鎖緊螺母之后，用扳手（30mm）轉動校平腳直到地面和輪腳之間的間距在5mm左右
b、 通過旋轉校平腳使框架達到水平
c、
2016-10-135910
-
Use of probe station
1. Load the sample into the vacuum chuck and turn on the vacuum valve control switch to make the sample securely and firmly adsorbed on the chuck.
2. Use the chuck X-axis / Y-axis control knob to move the chuck platform, and see the sample clearly under the microscope's low magnification objective lens.
3. Use the chuck X-axis / Y-axis control knob to move the ch
2016-05-135401
